STMicroelectronics

STM32WL55CC - Sub-G SoC


STM32WL55CC
Sub-GHz Wireless Microcontrollers. Dual-core Arm Cortex-M4/M0+ @48 MHz with 256 Kbytes of Flash memory, 64 Kbytes of SRAM. LoRa, (G)FSK, (G)MSK, BPSK modulations. AES 256-bit. Multiprotocol System-on-Chip.
STM32WL55CC - Sub-G SoC
Description

The STM32WL55/54xx long-range wireless and ultra-low-power devices embed a powerful and ultra-low-power LPWAN-compliant radio solution, enabling the following modulations: LoRa®, (G)FSK, (G)MSK, and BPSK. The LoRa® modulation is available in STM32WLx5xx only.

These devices are designed to be extremely low-power and are based on the high-performance Arm® Cortex®-M4 32-bit RISC core operating at a frequency of up to 48 MHz. This core implements a full set of DSP instructions. It is complemented by an Arm® Cortex®-M0+ microcontroller. Both cores implement an independent memory protection unit (MPU) that enhances the application security.

The devices embed high-speed memories (256-Kbyte Flash memory, 64-Kbyte SRAM), and an extensive range of enhanced I/Os and peripherals.

The devices also embed several protection mechanisms for embedded Flash memory and SRAM: readout protection, write protection and proprietary code readout protection.
In addition, the STM32WL55/54xx devices support the following secure services running on Arm® Cortex-M0+: unique boot entry capable, secure sub-GHz MAC layer, secure firmware update, secure firmware install and storage and management of secure keys.
These devices offer a 12-bit ADC, a 12-bit DAC low-power sample-and-hold, two ultra-low-power comparators associated with a high-accuracy reference voltage generator.
The devices embed a low-power RTC with a 32-bit sub-second wakeup counter, one 16-bit single-channel timer, two 16-bit four-channel timers (supporting motor control), one 32-bit four-channel timer and three 16-bit ultra-low-power timers.

These devices also embed two DMA controllers (7 channels each) allowing any transfer combination between memory (Flash memory, SRAM1 and SRAM2) and peripheral, using the DMAMUX1 for flexible DMA channel mapping.

All features

Radio
  • Frequency range: 150 MHz to 960 MHz
  • Modulation: LoRa®, (G)FSK, (G)MSK and BPSK
  • RX sensitivity: –123 dBm for 2-FSK(at 1.2 Kbit/s), –148 dBm for LoRa® (at 10.4 kHz, spreading factor 12)
  • Transmitter high output power, programmable up to +22 dBm
  • Transmitter low output power, programmable up to +15 dBm
  • Compliant with the following radio frequency regulations such as ETSI EN 300 220, EN 300 113, EN 301 166, FCC CFR 47 Part 15, 24, 90, 101 and the Japanese ARIB STD-T30, T-67, T-108
  • Compatible with standardized or proprietary protocols such as LoRaWAN®, Sigfox™, W-MBus and more (fully open wireless system-on-chip)

Ultra-low-power platform
  • 1.8 V to 3.6 V power supply
  • –40 °C to +105 °C temperature range
  • Shutdown mode: 31 nA (VDD = 3 V)
  • Standby (+ RTC) mode:360 nA (VDD = 3 V)
  • Stop2 (+ RTC) mode: 1.07 µA (VDD = 3 V)
  • Active-mode MCU: < 72 µA/MHz (CoreMark®)
  • Active-mode RX: 4.82 mA
  • Active-mode TX: 15 mA at 10 dBm and 87 mA at 20 dBm (LoRa® 125 kHz)

Core
  • 32-bit Arm® Cortex®-M4 CPU
    • Adaptive real-time accelerator (ART Accelerator) allowing 0-wait-state execution from Flash memory, frequency up to 48 MHz, MPU and DSP instructions
    • 1.25 DMIPS/MHz (Dhrystone 2.1)
  • 32-bit Arm®Cortex®-M0+ CPU
    • Frequency up to 48 MHz, MPU
    • 0.95 DMIPS/MHz (Dhrystone 2.1)

Security and identification
  • Hardware encryption AES 256-bit
  • True random number generator (RNG)
  • Sector protection against read/write operations (PCROP, RDP, WRP)
  • CRC calculation unit
  • Unique device identifier (64-bit UID compliant with IEEE 802-2001 standard)
  • 96-bit unique die identifier
  • Hardware public key accelerator (PKA)
  • Key management services
  • Secure sub-GHz MAC layer
  • Secure firmware update (SFU)
  • Secure firmware install (SFI)

Supply and reset management
  • High-efficiency embedded SMPS step-down converter
  • SMPS to LDO smart switch
  • Ultra-safe, low-power BOR (brownout reset) with 5 selectable thresholds
  • Ultra-low-power POR/PDR
  • Programmable voltage detector (PVD)
  • VBAT mode with RTC and 20x32-bit backup registers

Clock sources
  • 32 MHz crystal oscillator
  • TCXO support: programmable supply voltage
  • 32 kHz oscillator for RTC with calibration
  • High-speed internal 16 MHz factory trimmed RC (± 1 %)
  • Internal low-power 32 kHz RC
  • Internal multi-speed low-power 100 kHz to 48 MHz RC
  • PLL for CPU, ADC and audio clocks

Memories
  • 256-Kbyte Flash memory
  • 64-Kbyte RAM
  • 20x32-bit backup register
  • Bootloader supporting USART and SPI interfaces
  • OTA (over-the-air) firmware update capable
  • Sector protection against read/write operations

Rich analog peripherals (down to 1.62 V)
  • 12-bit ADC 2.5 Msps, up to 16 bits with hardware oversampling, conversion range up to 3.6 V
  • 12-bit DAC, low-power sample-and-hold
  • 2x ultra-low-power comparators

System peripherals
  • Mailbox and semaphores for communication between Cortex®-M4 and Cortex®-M0+ firmware

Controllers
  • 2x DMA controller (7 channels each) supporting ADC, DAC, SPI, I2C, LPUART, USART, AES and timers
  • 2x USART (ISO 7816, IrDA, SPI)
  • 1x LPUART (low-power)
  • 2x SPI 16 Mbit/s (1 over 2 supporting I2S)
  • 3x I2C (SMBus/PMBus®)
  • 2x 16-bit 1-channel timer
  • 1x 16-bit 4-channel timer (supporting motor control)
  • 1x 32-bit 4-channel timer
  • 3x 16-bit ultra-low-power timer
  • 1x RTC with 32-bit sub-second wakeup counter
  • 1x independent SysTick
  • 1x independent watchdog
  • 1x window watchdog

Up to 43 I/Os, most 5 V-tolerant

Development support
  • Serial-wire debug (SWD), JTAG
  • Dual CPU cross trigger capabilities

All packages ECOPACK2 compliant

*STMicroelectronics Authorized Distributor
訂閱電子報,掌握最新科技與產業趨勢 我要訂閱
訂閱電子報
© 2018 EDOM Technology. All Rights Reserved.
本網站使用Cookie為您提供最佳的使用體驗。繼續使用本網站,即表示您同意我們的Cookie Policy
接受